Linear Gate Motor & Opener Nationwide

Linear Gate Motor & Opener in West Hollywood: What to Know First

Linear gate motor & opener repair in West Hollywood is work we do regularly, and most jobs are diagnosed and fixed in a single visit. A typical Linear opener repair runs between $195 and $480 depending on whether we’re replacing a limit switch, a capacitor, or a full control board. A complete Linear motor replacement usually falls between $1,150 and $2,400, installed and tested, with the written price in your hand before any tool comes out of the truck. If you’ve got a Linear gate acting up, call (424) 321-7416 and a live person answers, day or night.

Call (424) 321-7416

This page is for West Hollywood homeowners who own a Linear swing or slide gate and want to know what’s actually wrong with it, what it costs to fix, and whether it’s worth repairing before they spend money. Not every Linear failure needs a new motor. Many don’t. We’ll tell you which one you have.

How Linear Products Fail - and How We Fix Them

Linear gate operators have a few failure patterns we see over and over in West Hollywood. Here are the five most common, with the model lines where they show up and what we do about them.

• Linear slide-gate operators (SL and SLR series) burning out the motor capacitor. The motor hums, won’t turn, and the gate sits mid-track. It’s almost always the start capacitor, a $30 part that takes a beating in our dry heat. We replace it, test the motor windings, and photograph the new capacitor installed. If the windings test weak, we tell you before we order a motor, not after.
• Linear swing-gate operators (LS, LA, and the older APSCO-badged units) tripping the thermal overload. The gate opens partway, stops, and won’t move again for ten minutes. The motor is overheating because the limit switches aren’t stopping travel in time, so the gate stalls against the post. We reset the limit positions, measure the current draw, and log both readings in your job record. If the limits were set wrong from day one, that’s good news: it’s a service call, not a motor replacement.
• Linear control boards (the APeX, LRA, and early M-series boards) failing to respond to remotes but working from the keypad. That’s usually a blown RF receiver circuit or a corroded terminal strip, not the motor. We trace it with a meter, verify it, and replace either the receiver module or the board. You get a photo of the old board with the fault marked, plus the part number of what went in.
• Linear photo-eyes (the infrared beam that stops the gate if something crosses) losing alignment. On Linear units, a misaligned photo-eye makes the gate refuse to close, which reads like a motor failure but isn’t. In West Hollywood, gate posts shift with soil movement after rain, and an eye that was perfectly aligned at install is now two inches off. We realign it, bag the lens, and record the beam voltage.
• Linear battery backup units (the BBK series) failing silently. The gate works fine until the power blinks, then it’s dead. Linear battery backups often sit untested for years and the battery sulfates. We load-test the battery under the operator’s actual draw, replace it if needed, and log the voltage. You’ll know your backup works because we prove it, not because it failed during a blackout.

Our Linear Gate Motor & Opener Process

Here’s how a Linear job runs from the moment you call (424) 321-7416 to the moment we leave your driveway in West Hollywood.

1. 1
   You call, a live person answers. No voicemail, no automated attendant, no “we’ll get back to you.” We ask what the gate is doing, what you’ve tried, and what brand and model you have if the label’s visible.
2. 2
   We diagnose on site. A technician arrives with the model’s wiring diagram, a meter, and the common Linear parts on the truck. We test the limits, capacitor, board voltage, and photo-eye beam before touching anything.
3. 3
   We write the price down. Under Haven Standard Clause 1, you get a written scope and a flat price before any repair starts. If the part we’d like to use is backordered and a quality aftermarket equivalent is available, we show you both options and the price difference.
4. 4
   We do the work. Motor replacement, board swap, limit reset, capacitor, whatever it is. We note anything else we find along the way and tell you immediately, with a price to address it now or later.
5. 5
   We test everything at least twice. The gate cycles under load, the safety eyes stop the gate, the limits open and close fully without stalling, and the backup battery (if present) is load-tested.
6. 6
   We hand you the record. Photos of the old part, the new part, the settings, and the test readings. Everything is filed in your job record. You leave with the same documentation we’d give a commercial client.

Before

After

What Linear Gate Motor & Opener Costs in West Hollywood

Here’s what we typically see on Linear work in West Hollywood:

• Linear limit switch reset and adjustment: $145-$195
• Linear motor capacitor replacement: $165-$240
• Linear photo-eye realignment or replacement: $125-$230
• Linear control board replacement (APeX or LRA): $385-$620
• Linear swing motor replacement (LS or LA series): $1,150-$1,850
• Linear slide motor replacement (SL series): $1,400-$2,400

What moves the price: whether the failure is electrical (cheaper) or mechanical (more labor), whether the arm brackets and mounting hardware are still intact, and whether we’re using OEM Linear parts or a quality aftermarket equivalent. The written estimate you get is the price you pay. Nothing gets added after the fact. Call (424) 321-7416 for a free estimate on your specific Linear setup.

Why West Hollywood Homeowners Call Vance Gate Repair West Hollywood for Linear Work

We’re an independent Linear service provider, not an authorized dealer, which means our recommendation is based on what’s best for your gate, not on what the manufacturer wants us to sell. We don’t push replacements when a $30 capacitor fixes the problem. But when a Linear motor is genuinely done, we’ll show you the test readings that prove it, then hand you a written price before anything is ordered.

Half the gates we see in West Hollywood weren’t installed by us. They carry LiftMaster, Mighty Mule, Ghost Controls, or DoorKing operators, and we work on all of them. So when a Linear gate fails, we can look at the whole system honestly, including whether the original Linear install is worth saving or whether a different brand’s newer motor would serve this gate better. Most of the time, the Linear is worth saving. The 365-Day Done Right Promise covers every Linear repair we complete. If it’s not right, we make it right, no argument and no fee.

FAQs